A little fettling and a new bottom!

After the welding that was done by Chris I need to fettle the new arch to fit, I had an hour on this and managed to get it so that the B'post side fits flush but the front near the step is like 7-10mm out in the curve of the arch so is going to need a bit of work... first I need to refit the cab door.

The door has seen better days and so I have set about bringing it back rather than buying a new one (Skint me !), there are no repair panels for the bottom of cab doors so it is fabrication all the way. I have cut out the biggest section where it is straight and fitted the new, profiled hand made section. Just a few more bits to do and then I will fit the new door skin.